FAQ

How to fill a motorcycle battery

What do you fill batteries with?

During normal operation batteries will only consume water – and not sulfuric acid. When your battery’s electrolyte is observed to be low, filling the battery with water will keep the battery healthy and safe for use.

Do you need to charge a battery after filling with acid?

The battery is ready to use after you’ve put the acid in, and you can charge it on the bike, however, better practice would be to attach it to a charger to complete the first charge… … On some bikes, the engine won’t function without a conductive, if not dead, battery in place.

How do you fill battery acid?

Pour distilled water into the acid reservoirs. A bottle that has a small spout is best so you can accurately and slowly pour in the distilled water. Don’t exceed the maximum level, because the acid expands when a battery gets charged. Never use water from your tap; it damages the plates in the cells.

What happens if you overfill a battery with water?

The answer is yes and the results are messy and potentially toxic and corrosive. The only time you add water to a lead acid battery is when it is fully charged. The reason for this is when a battery is fully charged the plates are thicker and the there is less space between them.13 мая 2018 г.

How long does it take to charge a 12v motorcycle battery?

between 4 to 24 hours

How long does it take to charge a brand new motorcycle battery?

So, how long does it take to charge a motorcycle battery? At least 6 hours and up to 24 hours. A brand new lead acid, 12 volt battery under a constant-current charge, will take 5 – 8 hours to charge up to 70%. The remaining 30% will require another 7 – 10 hours before it is ready to install on the motorcycle.

You might be interested:  How to remove rust from motorcycle fuel tank

How long does it take to charge a motorcycle battery at 2 amps?

Battery Charging Basic Rule. The basic rule in battery charging is to not charge a battery for more amp hours than the battery is rated to have. So a person who has a twelve amp battery would use a two amp charger on their battery for no longer than six hours. Six hours at two amps per hour should create twelve amps.

Can you put new acid in an old battery?

Generally speaking ,adding new acid to an old battery is a waste of time , if it won’t maintain charge then the plates are knackered and new acid won’t help .

Can I change the acid in my battery?

Older battery designs lose water in the electrolytea mixture of about one part sulfuric acid and two parts waterfrom evaporation. If you have this kind, check it twice a year and add distilled water only as needed. Adding acid actually makes a battery deteriorate faster.

What is the ratio of acid to water in a battery?

4. The correct ratio of water to sulfuric acid in battery electrolyte is approximately: 80 percent water to 20 percent sulfuric acid.

Can I put bottled water in my battery?

Because tap water contains minerals and natural content that could corrode the battery, it’s best to used bottled water. Use distilled or deionized water to fill your battery, as it doesn’t contain the mineral content of tap water.

How much water do I put in my battery?

The water level should be about a ½ inch above the tops of the plates to be considered in normal range. When adding more water, make sure you use distilled water. Tap water contains minerals that can diminish the performance of the battery and can increase the rate at which they self-discharge.

Leave a Reply

Your email address will not be published. Required fields are marked *