FAQ

How to install bar ends on motorcycle

Do you need bar ends on motorcycle?

Bar ends serve the simple purpose of protection. If your handlebars are wide enough and/or your bike is narrow enough, then your handlebars are susceptible to some damage in a fall. … Without the bar end, you could be looking at replacing your throttle tube, clip-on, or the entire handlebar if it is a one-piece unit.

What do motorcycle bar end weights do?

Those two things at the end of your handlebars are nothing but Bar End Weights or weight balancers (yes, they are heavyish). What they actually do is that they make sure the bike’s handlebar does not vibrate due to the resonance that occurs right from the moment when the engine of motorbike starts.

What are bar ends for?

Bar ends keep cables, hand grips and the handlebars themselves from getting beat up or scratched on rough ground or pavement. Keeping your handlebars off the ground is particularly important if you have carbon handlebars.

What is a riser bar on a bike?

What is a ‘riser’ bar? A riser mtb bar is again described in it’s title as it rises upward on each side. Riser bars, like flat bars, also include a backward sweep angle of around 7 – 9 degrees, but they also have upward bends to place the grip positions higher than the level of where the stem clamps to the bar.

How do I stop my motorcycle from vibrating?

To reduce these vibrations, here are a few things you can do:

  1. Olympia Anti-Vibe Gloves. Olympia 610 Anti-vibe Gloves are available in the market at an affordable price. …
  2. Fill Your Engine Oil. …
  3. Change Your Engine Oil. …
  4. Configuration of Disks and Brakes. …
  5. Valve tappets. …
  6. Changing your air filters. …
  7. Check up on your wheel chains.
You might be interested:  How to blackout motorcycle engine

Are bar end mirrors universal?

If you ride a motorcycle and aren’t thrilled with the stock mirrors, you can install bar-end mirrors instead. … These mirrors are a universal fit and can be installed on either side. They have a 360-degree adjustable arm and can be cranked around if you need to fit your bike in a tight spot.

How do you get a stuck Bar end out?

A lot of barends have like a wedge tensioner in the middle, so you have to unscrew the one screw most of the way, and then take a hammer and tap it back in to release the tension. Then it’ll just pop out.

Leave a Reply

Your email address will not be published. Required fields are marked *