FAQ

How to install handlebar risers on a motorcycle

What do motorcycle handlebar risers do?

Simply put, these handlebar risers can dramatically change the position of your handlebars to suit your upper body and riding style. By changing the position of your upper body and distance to the handlebars, you can achieve better control and comfort on virtually any motorcycle.

Do handlebar risers affect handling?

If you are short, increasing the height of the handle bar makes it difficult to move and get a good control on the bike while moving it specially during parking. You feel the bike is harder to move as you are not able to reach the height. Shorter the height of the bike handle, easier it is to move the bike.

Do I need handlebar risers?

The best way to know for sure if they’re for you is to try them out. If you’re leaning forward or down too much with your shoulders hunched & get uncomfortable riding that way even for short distances, you’ll benefit from risers. At 6′ I would suggest 2″ risers for you.

How do risers work?

How Do Risers Work? … Similar to pipelines or flowlines, risers transport produced hydrocarbons, as well as production materials, such as injection fluids, control fluids and gas lift. Usually insulated to withstand seafloor temperatures, risers can be either rigid or flexible.

What is the legal height of handlebars on a motorcycle?

c) The highest point on the handle bar must not be more than 380mm (W) above the top of steering yoke. d) Where the highest point of the handle bar is more than 205mm vertically above the top of steering yoke (W), the distance between the extreme ends of the handle bar (V) must not be less than 660mm.

You might be interested:  Why i ride a motorcycle

How do I know what size handlebars to get?

Measuring Bar Diameter

Just wrap around the bar at the point you want to attach the Oi to get the circumference size and then divide by pi (…. mmm) to get your diameter e.g. 99.9mm / = 31.8mm. If you have no tape, then use a piece of paper (or string).

What does pull back on handlebars mean?

Pullback describes the angle on a horizontal plane of the grip area of the handlebars. Picture laying your hand flat on a table and flexing your wrist left to right. There is little more than 35 degrees or so of motion possible and a narrow comfort zone, illustrating the importance of getting the pullback right.

Are wider handlebars better?

When it comes to mountain bike handlebars, wider is better. They offer you more control, easier breathing and better positioning for balance. This makes you more stable and slower to fatigue. As with any component so intimately related to fit, handlebar width is relative.

Are ape hanger handlebars illegal?

High-set ape hanger bars were banned in 30 American states in the 1960s. The American was on the pretext of safety, but was more likely introduced so police had reason to pull over and search riders believed to be members of outlaw motorcycle gangs.

What is a riser handlebar?

What is a ‘riser’ bar? A riser mtb bar is again described in it’s title as it rises upward on each side. Riser bars, like flat bars, also include a backward sweep angle of around 7 – 9 degrees, but they also have upward bends to place the grip positions higher than the level of where the stem clamps to the bar.

You might be interested:  How to get your motorcycle license in az

Do you need bar ends on motorcycle?

Bar ends serve the simple purpose of protection. If your handlebars are wide enough and/or your bike is narrow enough, then your handlebars are susceptible to some damage in a fall. … Without the bar end, you could be looking at replacing your throttle tube, clip-on, or the entire handlebar if it is a one-piece unit.

Are bike stem risers safe?

Absolutely yes! Unless you want to use them on a carbon steerer… Carbon flexes too much for that increased length to be safe.

Leave a Reply

Your email address will not be published. Required fields are marked *