FAQ

How to replace a clutch lever on a motorcycle

How do you loosen a motorcycle clutch lever?

How to Adjust the Clutch Lever

  1. Pull back the rubber cover from the clutch lever, and loosen the larger lock nut by unscrewing it with your fingers.
  2. Screw the smaller “adjusting nut” outward to reduce free play and tighten the lever, or inward for the opposite effect.

Where is the clutch lever on a motorcycle?

The clutch lever is located on the left side of the handlebar. It disengages and engages the power from the engine to the rear wheel.

Why is my motorcycle clutch so hard to pull?

There are several factors that can contribute to a stiff clutch. An old, worn or dirty clutch cable is one reason. Other factors include dirty lever, stiff clutch springs, dirty or worn actuator arm or push rod. Clutch position and hand strength can also be a factor.

How tight should a motorcycle clutch cable be?

A correctly adjusted clutch cable should have about 1/8” of free play measured at the pivot. When we have too much free play at the lever, the clutch is never fully engaged when we pull the clutch lever. This results in harder shifting and increased clutch wear.

Why is 1st gear down on a motorcycle?

1) First gear is designed only to move the vehicle from rest to start, whereas other gears are for changing the speed. … The reason for neutral between first and second Gears, whether it is foot operated motor bikes or Hand operated Scooters, wherein the Gear will shift with Cylindrical rotation.

You might be interested:  How to measure for a motorcycle windshield

Where is the front brake lever on a motorcycle typically located?

On the right side of the handlebars you have the front brake lever and the twist throttle. The brake lever works just like a bicycle; you pull the lever in and the bike stops.

What hand is the clutch on a motorcycle?

On a motorcycle equipped with a suicide clutch, the clutch is held in with the left foot, requiring the right foot to hold the bike in place, with the right hand applying pressure to the front brake.

Leave a Reply

Your email address will not be published. Required fields are marked *