Interesting about motorcycles

How to check a motorcycle coil

How do you test a motorcycle coil?

How to Check a Motorcycle Ignition Coil

  1. Turn off the motorcycle ignition.
  2. Disconnect the spark plug wires from the coil by hand. Disconnect the two smaller primary wires from the coil using an open-ended wrench.
  3. Measure the resistance between the coil connections for the spark plugs with an ohmmeter. The resistance should be 0.5 to 3 ohms.

How do you check if a coil is bad?

The only safe way to test for spark is to use a spark plug tester tool. If a coil problem is suspected, measure the coil’s primary and secondary resistance with an ohmmeter. If either is out of specifications, the coil needs to be replaced. A coil can be easily bench tested with a digital 10 megaohm impedance ohmmeter.

How do you check a coil with a multimeter?

Connect your multimeter to the positive terminal or pin of your coil, and to the high output terminal that goes to the spark plug. Most ignition coils should have a secondary resistance falling somewhere between 6,000 to 10,000 ohms;however, refer to manufacturer specifications for the correct range.

Will a motorcycle start with a bad Rectifier?

The rectifier is part of the charging system. If you put a freshly charged battery in your motorcycle, and you have a bad rectifier, it won’t stop your motorcycle from starting, but your battery wouldn’t stay charged. The regulator/rectifier on your motorcycle performs two functions.

What does a bad ignition coil sound like?

If you try to start your engine up and you hear a spluttering sound repeatedly, then you are likely experiencing an engine misfire that can be attributed to a bad ignition coil. You may still be able to drive your vehicle, but you will hear a lot of strange noises and even feel jerkiness as you accelerate the vehicle.

You might be interested:  How to build a go kart with motorcycle engine

Is it OK to drive with a bad ignition coil?

It’s not recommended to drive it at all with a bad coil pack or coil packs all you going to do is just cause more problems for yourself as far as raw fuel dumping into the exhaust which could ignite at some point clogged catalytic converter or melted or just cause problems with the catalytic converter O2 sensors things …

How many ohms should a 12 volt coil have?

You should have a resistance reading of at least 3-4.5 ohms. A bad coil will show a higher reading then 3-4.5. Next, place the red or black lead from the meter to the centre of the coil , and to either one of the terminals positive or negative. You want 9500-10000 Ohms, less is on but no more.

Do you need a resistor with a 12 volt coil?

When a 6 volt ignition system is converted to 12 volts either a 12 volt coil must be installed or a resistor installed in the circuit to reduce the coil voltage to 6 volts. The resistor regulates the voltage, keeping it at 6 volts, allowing the original 6 volt coil to be used in a 12 electrical system.

Leave a Reply

Your email address will not be published. Required fields are marked *