Tips

How to adjust motorcycle clutch

Why is my motorcycle clutch so stiff?

There are several factors that can contribute to a stiff clutch. An old, worn or dirty clutch cable is one reason. Other factors include dirty lever, stiff clutch springs, dirty or worn actuator arm or push rod. Clutch position and hand strength can also be a factor.

How do you adjust a clutch?

To adjust, simply pull up on the clutch cable and loosen the locknut and the adjuster nut slightly. Next, slowly pull up on the clutch cable again. You will feel a point where the clutch fork engages. This is where the clutch cable should be adjusted to.

How tight should a motorcycle clutch cable be?

A correctly adjusted clutch cable should have about 1/8” of free play measured at the pivot. When we have too much free play at the lever, the clutch is never fully engaged when we pull the clutch lever. This results in harder shifting and increased clutch wear.

Can a clutch cable be adjusted?

The first step is to loosen the locknut and adjuster nut slightly. Next pull up on the clutch cable and make sure the locknut and adjuster can be turned by hand. Step 2: Adjust the clutch lever. … This is where the clutch cable should be adjusted too.

Is it bad to hold in the clutch on a motorcycle?

No, this won’t hurt your motorcycle in any way, and you will save fuel, because your engine at idling speed will obviously use up much less fuel than having it at higher revolutions, but disengaging your clutch will also disengage your engine braking, and add to the stress on the brakes if you need to slow down.

You might be interested:  What is a rectifier on a motorcycle

How long should motorcycle clutch last?

20,000 to 50,000

Where should the clutch bite?

The bite point is usually around half way through the clutches working travel (around mid-way from fully pressed to fully released). The does however vary a little from car to car. An experienced driver will have little need to use the bite point except for very slow moving traffic and moving off on a hill.

Can you change the biting point on a clutch?

Mechanics typically have different opinions on the optimum clutch biting point, and some will even go as far as adjusting your biting point for you. As long as it works for you, there’s no need to change it; which is brings us to the meat and potatoes of our debate.

How do you know if your clutch needs adjustment?

Symptoms of a Bad or Failing Clutch Cable Adjuster

  1. Difficulty disengaging the clutch. One of the first symptoms commonly associated with a bad or failing clutch cable adjuster is difficulty disengaging the clutch. …
  2. Loose clutch pedal. Another symptom of a problem with the clutch cable adjuster is a loose clutch pedal. …
  3. Excessively tight clutch cable.

When should I replace motorcycle clutch cable?

Grease yours once a year or so and replace it every 30 or 40,000 miles (consult your owners manual for service schedule) and you’ll likely never break one. Clutch cables break by fraying, popping one strand after another over time.

How do I know if my clutch cable has gone?

Symptoms of a Bad or Failing Clutch Cable

  1. Transmission slips out of gear. A bad clutch cable can sometimes cause a transmission to slip and pop out of gear. …
  2. Hard clutch pedal. Another symptom of a problem with the clutch cable is a hard clutch pedal. …
  3. Clutch pedal sinks to the floor.

Leave a Reply

Your email address will not be published. Required fields are marked *