Tips

How to change a motorcycle chain

Is it hard to change a motorcycle chain?

Replacing a set of sprockets and a chain isn’t hard if you have a repair manual, the required tools, and a way to lift up the motorcycle so the rear wheel is off the ground. … Once that nut is loose you can go to the back end of the motorcycle and loosen the rear axle bolt and the chain tension adjuster bolts.

How often should you change your motorcycle chain?

But chains wear out over time and need replacing. So, how often should a motorcycle chain be replaced? In general, a properly maintained motorcycle can will last 20,000 to 30,000 miles, sometimes more. But, some last as little as 5,000 to 10,000 miles.

How do I know if my motorcycle chain needs Lube?

Lick it. I’ll usually inspect it every 2-3 weeks (unless something feels off) and if it looks dry or is starting to get gunk/rust on it I’ll scrub it down and lube it back up.

What happens if motorcycle chain breaks?

You will loose power from your back wheel because the chain is no longer delivering the drive the engine is giving. The engine will still be going, but you will not be able to accelerate. In fact, your motorcycle may start decelerating if you’re not going down a hill at all.

What is the best motorcycle chain lube?

The Best Motorcycle Chain Lube

  1. DuPont Teflon Chain Saver Lubricant. See More Reviews. …
  2. Maxima 74920 Chain Wax Aerosol. See More Reviews. …
  3. PJ1 Blue Label Motorcycle Chain Lube. …
  4. Motul M/C Care Factory Line Chain Lube. …
  5. Lucas Oil 10393 Chain Lube. …
  6. Bel-Ray Super Clean Chain Lube. …
  7. DuPont Teflon Multi-Use Lubricant. …
  8. Liquid Wrench L711 Chain & Cable Lube.
You might be interested:  How to remove motorcycle grips

How tight should a motorcycle chain be?

On average, however, most street motorcycles will need a chain tension of about 20 – 30 mm, or about a half inch to an inch in slack. This means that the chain should be able to move about a half inch to an inch up and about a half inch to an inch down. It’s easiest to measure this using a measuring tape.

Can you break a chain without a tool?

A hammer (or a brick), punch (or a nail), something sturdy with a small hole in it. Place the chain on the sturdy thing with the pin over the hole, use the hammer and punch to drive the pin down, but not all the way. Three quarters maybe. Bend the chain a bit and it should split.

Can I take a link out of my motorcycle chain?

If you’re removing your old bike chain, find the master link (it should be the one that’s different from all the rest) … Once you’ve ‘broken’ apart the master link the chain will come apart and you can pull it through and free of the bike.

How much does it cost to replace a bike chain?

How much does a bike chain cost to replace? Entry level chains can start off around $15.00 with more expensive and higher performance chains ranging from $25.00 to $60.00 or more. More expensive chains increase shift quality and are generally more durable as they wear.

Leave a Reply

Your email address will not be published. Required fields are marked *