Tips

How to lube a motorcycle chain

How often should I lube my motorcycle chain?

Q: How often should I lubricate my motorcycle chain? A: While it may enhance your motorcycle’s performance to lubricate your chain after every ride, you should ideally apply lube after every 300 miles, or once every 100 miles if your chain is unsealed.

Do motorcycle chains need lube?

“A chain needs to be lubricated.” Derek says. … “Any chain will rust if it’s not lubricated, and the seals will become dry and crack, letting that grease escape. And remember, you’re lubricating the sprocket, not just the chain.

Can you use wd40 on a motorcycle chain?

It is highly recommended that you do not use Multi-Purpose WD-40 on your motorcycle chain. The WD stands for Water Displacement, and it is designed to disperse water away from metal parts to prevent rust.

Can you over lube a motorcycle chain?

It’s amazing how fast even a clean chain attracts dust and crap. Plus too much lube just means it gets all over other bike parts (derailleurs, cranks, frame) which then attracts more dust and crap. Just make sure to use the right lube for the conditions (wet for wet conditions, dry for dry) and wipe off any excess.

How long should motorcycle chain last?

But chains wear out over time and need replacing. So, how often should a motorcycle chain be replaced? In general, a properly maintained motorcycle can will last 20,000 to 30,000 miles, sometimes more. But, some last as little as 5,000 to 10,000 miles.

How often should you wash your motorcycle?

every two weeks

You might be interested:  How to paint motorcycle plastic

What happens if you don’t lube your motorcycle chain?

If the chain is not lubricated it will wear prematurely. … This has the effect of changing the distance between the rollers.As the chain grows it will no longer match the pitch of the drive sprockets, the sprockets will wear out prematurely. If you then change the chain it will be worn by the old sprockets.

Is Chain Wax better than lube?

Also, keep in mind that you tend to use more wax than lube in a single application. If you want to use your motorcycle immediately you lubricate the chain, then you’ll be better off using chain lube. It does the job faster and reaches all the areas of your chain, making things move smoother faster than the wax.

Is dry lube good for motorcycle chain?

Best chain lube: Dry lube

Non-toxic and biodegradable, Finish Line’s dry lube is very effective at repelling dirt, making it a good choice for dry and dusty riding. Teflon is used in this dry lube to reduce friction and mechanical wear as it penetrates into all the nooks and crannies for complete protection.

Why is wd40 bad for bike chains?

WD40 is primarily a solvent, which means that it dissolves contaminates so parts get nice and clean. As a solvent, WD-40 will strip away any existing lubricant, leaving your chain, and drivetrain dryer than before application. This means that using WD-40 as a chain lubricant is worse than using no lube at all.

Is it OK to pressure wash a motorcycle?

“If your bike is really dirty, you can use a pressure washer to get the worst of the grime off. But, be careful. Motorcycles are water resistant, not waterproof. Use high pressure water for the wheel rims and under the fenders, but be careful around the engine, where the electronics are.

Leave a Reply

Your email address will not be published. Required fields are marked *