Tips

How to test a motorcycle coil with a multimeter

How do you know if your motorcycle coil is bad?

How to Check a Motorcycle Ignition Coil

  1. Turn off the motorcycle ignition.
  2. Disconnect the spark plug wires from the coil by hand. Disconnect the two smaller primary wires from the coil using an open-ended wrench.
  3. Measure the resistance between the coil connections for the spark plugs with an ohmmeter. The resistance should be 0.5 to 3 ohms.

How do you check an ignition coil with a multimeter?

Connect your multimeter to the positive terminal or pin of your coil, and to the high output terminal that goes to the spark plug. Most ignition coils should have a secondary resistance falling somewhere between 6,000 to 10,000 ohms;however, refer to manufacturer specifications for the correct range.

How do I check if my ignition coil is bad?

The only safe way to test for spark is to use a spark plug tester tool. If a coil problem is suspected, measure the coil’s primary and secondary resistance with an ohmmeter. If either is out of specifications, the coil needs to be replaced. A coil can be easily bench tested with a digital 10 megaohm impedance ohmmeter.

What are the signs of a bad stator?

Runs bad at lower rpms but runs good at higher rpms (Low speed coil going bad) Runs good at lower rpms but runs bad at higher rpms (High speed coil is going bad) Backfiring and just won’t run good. Sled slowly loses power during the course of the day.

Will a motorcycle start with a bad Rectifier?

The rectifier is part of the charging system. If you put a freshly charged battery in your motorcycle, and you have a bad rectifier, it won’t stop your motorcycle from starting, but your battery wouldn’t stay charged. The regulator/rectifier on your motorcycle performs two functions.

You might be interested:  How to sell a motorcycle with a lien

How many ohms should a 12 volt coil have?

You should have a resistance reading of at least 3-4.5 ohms. A bad coil will show a higher reading then 3-4.5. Next, place the red or black lead from the meter to the centre of the coil , and to either one of the terminals positive or negative. You want 9500-10000 Ohms, less is on but no more.

What does a bad ignition coil sound like?

If you try to start your engine up and you hear a spluttering sound repeatedly, then you are likely experiencing an engine misfire that can be attributed to a bad ignition coil. You may still be able to drive your vehicle, but you will hear a lot of strange noises and even feel jerkiness as you accelerate the vehicle.

What causes a stator to fail?

There are a few things that may cause a stator to fail. Too heavy of a load when operating accessories (winch,heated grips,headlights, etc). If working several of these items at one time (plowing/pulling/possibly stuck at night) you would overload the system. This could cause either the stator or rectifier to fry.

Leave a Reply

Your email address will not be published. Required fields are marked *