Useful

How to lube motorcycle cables

What is the best lubricant for motorcycle cables?

Choosing The Correct Lubricant

Regular motor oil works great if you don’t have an appropriate aerosol product. If you want to do it the right way, we suggest a product that is formulated for cables.

Should you Lube Bike cables?

Cable lubrication is recommended, especially if you ride in the rain or have old cable housings. Most brake and shift cables these days have a plastic lining built into the housing, therefore eliminating the need for lubrication.

Can you use chain lube on cables?

Cheers! Use silicone lubricant. Oil based lubricants can cause the inner nylon sheath to swell (it absorbs the hydrocarbon liquid) and increase wear. … Use the WD-40 to break it free and flush the gunk out of the cable then use the chain lube as long as its not too tacky.

What is Cable Lube?

Wire-pulling compound, also called cable lube or lubricant, is designed to make it easier to pull electrical wires and cables through conduit runs.

What can I use as lube for cable?

I use that Dupont Teflon spray as chain lube as well, so far so good. I’ve always used WD40, but some silicon-type universal lubricant or similar would do the job as well if not better. WD40 is more of a cleaner, not a lubricant. It’ll remove whatever lubricant there was and then evaporate away.

Is it OK to use wd40 on bike chain?

As a solvent, WD-40 will strip away any existing lubricant, leaving your chain, and drivetrain dryer than before application. This means that using WD-40 as a chain lubricant is worse than using no lube at all. … REI does not recommend using WD-40 on your bike (it is a cleaner but not a lubricant).

You might be interested:  How to put saddlebags on a motorcycle

Are brake cables and gear cables the same?

While brake and gear inner cables are nominally similar, the housings are different – brake cables use conventional ‘helical’ housing which consists of a tightly-wrapped helix of steel wire lined on both inside and outside by a plastic coating.

Do I need to lube a new clutch cable?

No you dont. The cables are teflon coated inside and oil can break that down.

When should you replace bike cables?

5000 to 6000 miles is a good time frame to replace the cables. Other wise wait till they brake and either have a good stiff pedal in or nice easy spin, depending on the broken cable. Most likely it won’t be the brake cable that will go. 5000 to 6000 miles is a good time frame to replace the cables.

Leave a Reply

Your email address will not be published. Required fields are marked *