Useful

What is a stator in a motorcycle

What can cause a motorcycle stator to go bad?

There are a few things that may cause a stator to fail. Too heavy of a load when operating accessories (winch,heated grips,headlights, etc). If working several of these items at one time (plowing/pulling/possibly stuck at night) you would overload the system. This could cause either the stator or rectifier to fry.

How do stators work?

In an electric motor, the stator provides a rotating magnetic field that drives the rotating armature; in a generator, the stator converts the rotating magnetic field to electric current. In fluid powered devices, the stator guides the flow of fluid to or from the rotating part of the system.

How do you test a motorcycle stator?

Insert each probe into a stator socket. You should read around 0.2 to 0.5 ohms. If you show an open circuit with the “Open” or infinity reading or have higher resistance, then the stator is bad and you must replace it. If these tests all produce positive results, then the stator itself is good.

Will a motorcycle start with a bad Rectifier?

The rectifier is part of the charging system. If you put a freshly charged battery in your motorcycle, and you have a bad rectifier, it won’t stop your motorcycle from starting, but your battery wouldn’t stay charged. The regulator/rectifier on your motorcycle performs two functions.

Will a motorcycle run without a stator?

only for as long as the battery has power to supply. The stator creates voltage that passes through the rectifier. The rectifier provides power for firing the plugs and also re-charges the battery.

You might be interested:  How to get botw motorcycle

Does a motorcycle charge at idle?

Technically, a motorcycle battery does charge while the motorcycle is idling though it does not provide as much amperage as when the motorcycle is at higher speeds. During a normal ride, a motorcycle provides about 13, 14, or 15 amps while idling only provides less than 1 amp.

What voltage should a stator put out?

For example a 32-amp stator should put out 18 volts AC (VAC) per each 1000-RPM. At 2000 it should be 36 VAC (18×2). At 3000 RPM it should be 54 VAC (18 X 3). Each system has a certain voltage it should produce per 1000 RPM.

What are the signs of a bad stator?

Runs bad at lower rpms but runs good at higher rpms (Low speed coil going bad) Runs good at lower rpms but runs bad at higher rpms (High speed coil is going bad) Backfiring and just won’t run good. Sled slowly loses power during the course of the day.

Can a bike run without a CDI?

Yes, you can with a mechanical unit. But customizing one will take lots of time and effort. It might be even more costly to custom build one as the CDI on the market shelf is mass produced one hence efficiently produced. That will keep it’s price reasonably low.

Can a bad stator damage a battery?

As far as the battery, yes a bad stator/regulator can destroy a new battery. If it’s run at a very low voltage without being recharged then it can be destroyed. It actually happens all the time. In most cases if we replace a stator or regulator the battery has to be changed as well as it won’t hold a charge.

You might be interested:  How to get title for motorcycle

What is the purpose of a rectifier on a motorcycle?

Motorcycle Charging System Components

The regulator/rectifier changes, or rectifies, the alternating current produced by the alternator into direct current so it can be stored in the battery and regulates the amount of current produced to prevent overcharging.

How do I know if my motorcycle rectifier is bad?

First, the diode can burnout and cause the battery to drain. You won’t have any trouble diagnosing the faulty regulator rectifier if the battery is the cause. You’ll note signs right away like poor starts, fluctuating meter readings, and dimmed headlights. around 13 volts, the bike will start to drain the battery.

Leave a Reply

Your email address will not be published. Required fields are marked *